Tenergy Universal Smart Charger

• Best Charger for charging all RC Car, RC Airplane and Airsoft battery packs 7.2V, 8.4V, 9.6V and 12V.
• Universal for any NiMH /NiCd battery packs 7.2V - 12V (6-10 Cells pack)
• Fast charger with current switch to select either, 0.9A and 1.8A. Delivers full charge within 1 - 2 hours.
• Charging Current 0.9A for battery packs with capacity from 900mAh -1800mAh.
• Charging Current 1.8A for battery packs with capacity above 2000mAh. For 3000mAh pack, charging time is 1.5 hours.
• Smart Charger with automatic voltage detection.
• Use pulse and negative pulse technology to avoid battery overheating during fast charging, optimized for battery pack's cycle life.
• Red LED will be on during charging.
• Automatically charging ending with negative delta V.
• 4 hour safety timer: Charger will stop charging after 4 hours of operation.
• Worldwide usage with 120-240V AC
• With Temperature sensor
• Safety protection fuse for over current, short circuit & reverse polarity protection.
• Weight: 10.7 oz

Accessories Included

• 1 standard Tamiya connector.
• 1 connector adapter from standard Tamiya to Mini Tamiya.
• 1 set of alligator clip adapter with standard Tamiya connector on one end.
• 1 Temperature sensor

Smart Charger Specification

• FOR 7.2V-12V NI-MH/NI-CD BATTERY PACK 6-10PCS BATTERY
• Input: AC100-240V
• Output: 7.2-12V 0.9or1.8A

Operation Instruction

• Connect battery pack to output connector and plug AC power source.
• Make sure battery polarity is connected correctly (Red wire is positive)
• Charger will detect battery voltage automatically, Red LED will be on during charging
• When battery is fully charged, current will reduce to trickle charging at 50mA, Green LED will be on
• Battery will be charged at 0.9A or 1.8A constant current,
• Approximate Charging time is about 1.5hrs for 3000mAh battery,1hr for 1800mAh battery.
• The charger is designed for faster charging NiCd and NiMH battery packs from 6 to 12V for RC car/Air and Air soft gun.
• Don't charge battery packs with voltage less than 6V or voltage greater than 12V and capacity smaller than1100mAh.
• Battery pack must be made by high drain current cell.
• Please contact your seller for instruction. Mfg is not responsible for any damage and consequent damage by Misusage.

Caution

• The charger is designed for indoor use only. Don't leave the charger unattended during charging.
• The Charger should be positioned horizontally and work in well ventilated condition, avoid water and keep away from flammable explosive goods.
• Don't cover the charger when charging, ambient temperature shall not be more than 40oC
• Don't touch the plug.
• Don't leave the batteries and chargers on wood surface or carpet.
• Cut off the power supply before connect or disconnect the charger with batteries.
• Don't try to disassemble the charger, High voltage inside, danger!